Sometimes there is need to convert line level signals to such signal that it can be connected to microphone input. Because the line level signals are typically in range of 0.5..2V and the microphone signals are in millivolt range, quite much attenuation is needed to match the signal levels. This means that typically you will need 40-50 dB of attenuation.
Consumer audio line (-10dBu) level to microphone
matching can be done using a "40 dB L-pad attenuator".
This circuit is indeed quite simple:
+Line level input -----R1----+-- +Mic level output
|
+----R2----+
|
Ground (input)----+--------------- Ground (output)
R1 = 10 kohm
R2 = 100 ohm
Circuit technical data:
Professional audio audio line level (+4dBu) to microphone
matching can be done using a "50 dB L-pad attenuator".
This circuit is indeed quite simple:
+Line level input -----R1----+-- +Mic level output
|
+----R2----+
|
Ground (input)----+--------------- Ground (output)
R1 = 33 kohm
R2 = 100 ohm
Circuit technical data:
The circuit itself can be built to a small metal box or even can be fitted inside an audio connector. The resistors in this circuit do not need more than 1/4W power rating (even lower ratings will do). I would recommend using metal film resistors in this circuit, because they are less noisy than cheap carbon film resistors.
I don't recommend building the circuit to a plastic box because we are playing with low level microphone signals, so the interference from nearby equipments or cellular phones can be a signnificant if you build this circuit to a plastic box or without any box. If you plan to use the circuit in any serious audio system do yourself a favor and build a circuit to a good metal box.
Balanced Taper Pad: 50dB (for 600 ohm impedance, XLR connector)
XLR in XLR out
1 ------------------ 1
2 ---R1---+---R2--- 2
|
R3
|
3 ---R1---+---R2--- 3
Component values:
R1 = 300 ohms R2 = 300 ohms R3 = 4 ohms
---R1---+---R2---
|
-> Z1 R3 Z2 ->
|
---R1---+---R2---
R1 = ((Z1 + Z2)* 0.994 + (Z1 - Z2))/4 R2 = ((Z1 + Z2)* 0.994 - (Z1 - Z2))/4 R3 = (Z1 + Z2)/317.3
Example: Z1=600R Z2= 600R
Then R1=298 ohms, R2=298 ohms, R3=3.78 ohms